Configuration steps
From Notes_Wiki
Revision as of 06:30, 4 December 2025 by Kalyan (talk | contribs) (Created page with "Home >Configuration Steps *Configure Management Interface and Gateway *Set Strong Administrative Passwords *Apply Access Control Lists (ACLs) for Management Access *Configure Spanning Tree Protocol (STP) Consistently *Enable Port Security (If Applicable) *Enable Storm Control (If Needed) *Verify LACP Status *Disable Unused Ports *Configure Jumbo MTU (If Required) *Set Date, Time, and NTP Configuration *Configur...")
- Configure Management Interface and Gateway
- Set Strong Administrative Passwords
- Apply Access Control Lists (ACLs) for Management Access
- Configure Spanning Tree Protocol (STP) Consistently
- Enable Port Security (If Applicable)
- Enable Storm Control (If Needed)
- Verify LACP Status
- Disable Unused Ports
- Configure Jumbo MTU (If Required)
- Set Date, Time, and NTP Configuration
- Configure Syslog
- Enable SNMP or NMS Monitoring
- Backup Configuration
- Firmware and Configuration Baseline
- Hostname and Device Naming Convention
- Banner and Login Message
- VLAN and Trunk Configuration Validation
- Loop Protection / BPDU Guard
- Temperature and Hardware Health Check
- Interface Description and Documentation
- Post-Deployment Handover
