Difference between revisions of "Configuring Dell N4032 switch in stack mode"
From Notes_Wiki
(Created page with "<yambe:breadcrumb>Switch_configuration_notes|Switch configuration</yambe:breadcrumb> =Configuring Dell N4032 switch in stack mode= For configuring Dell N4032 switch in stack...") |
m |
||
| Line 1: | Line 1: | ||
[[Main Page|Home]] > [[Switch configuration notes]] > [[Configuring Dell N4032 switch in stack mode]] | |||
For configuring Dell N4032 switch in stack mode use following steps using Web based configuration GUI: | For configuring Dell N4032 switch in stack mode use following steps using Web based configuration GUI: | ||
| Line 13: | Line 12: | ||
</pre> | </pre> | ||
stacking configuration and stacking unit information would be visible. | stacking configuration and stacking unit information would be visible. | ||
[[Main Page|Home]] > [[Switch configuration notes]] > [[Configuring Dell N4032 switch in stack mode]] | |||
Latest revision as of 06:10, 19 April 2022
Home > Switch configuration notes > Configuring Dell N4032 switch in stack mode
For configuring Dell N4032 switch in stack mode use following steps using Web based configuration GUI:
- Connect any two ports of the two switches with each other. Say port 23 of one switch with port 23 of other switch.
- Convert port type from Ethernet to Stack for this port in both switches
- Reboot switches. One which reboots first should become master. Only connectivity to master over IP would work. If master fails the other switch would be accessible over this IP only.
If stacking is working then two units in stack would be visible in web based switch configuration GUI. Further on command-line in
show running-config show version
stacking configuration and stacking unit information would be visible.
Home > Switch configuration notes > Configuring Dell N4032 switch in stack mode
