Configure lacp or port-channel on Aruba switches (Trunk)

From Notes_Wiki

Home > Switch configuration notes > Configure lacp or port-channel on Aruba switches (Trunk)

On Aruba switch lacp or port-channel is called Trunk (Normal VLAN Access / trunk is called tagged /untagged). So we can create a trunk and add members to trunk for ether-channel or lacp operations using:

trunk trk1 lacp <port-no>
trunk trk1 lacp <port-no>

where instead of trk1 we can use trk2, trk3, etc. for additional trunks as and when required.

Refer:


Note that this is quite different than trunk port on Cisco / Dell etc. where all / multiple VLANs traffic is sent in tagged manner. Typical trunk access configuration might look like:

vlan <id>
   tagged <ports-list>
   untagged <ports-list>
   ip address <ip> <netmask>

where we can have multiple VLANs configured as tagged for same interface to make it trunk for those VLANs. If a particular interface has only one VLAN untagged then that interface is similar to access VLAN for that VLAN ID.




Home > Switch configuration notes > Configure lacp or port-channel on Aruba switches (Trunk)