CentOS 7.x installing lxc

From Notes_Wiki
Revision as of 03:03, 15 October 2017 by Saurabh (talk | contribs)

<yambe:breadcrumb>CentOS_7.x_lxc|CentOS 7.x lxc</yambe:breadcrumb>

CentOS 7.x installing lxc

To install lxc use following steps:

  1. Install lxc package using
    yum -y install epel-release
    yum -y install debootstrap perl libvirt libcap-devel libcgroup wget bridge-utils
    yum -y install lxc lxc-templates lxc-extra
  2. Check that system supports lxc
    lxc-checkconfig
    Before booting a new kernel its support for lxc-can be checked using:
    CONFIG=/boot/config-3.10.0-514.2.2.el7.x86_64 /bin/lxc-checkconfig
    where config-3.10.0-514.2.2.el7.x86_64 should be replaced with configuration file for new kernel
  3. Start and enable lxc on boot
    systemctl start lxc.service
    systemctl enable lxc.service
    systemctl status lxc.service
  4. Reboot base host for more stability


Refer:


Get more space for lxc containers

To get more space for lxc-containers from other partition which by default use /var use following steps: (Replace /mnt/data1 in below steps and commands with mount-point where more space is available in your installation)

  1. Stop all running containers. Verify 'lxc-ls --active'
  2. mkdir /mnt/data1/lxc-files
  3. mkdir /mnt/data1/lxc-files/{var_cache_lxc,var_lib_lxc}
  4. mv /var/cache/lxc/* /mnt/data1/lxc-files/var_cache_lxc/
  5. rmdir /var/cache/lxc
  6. ln -s /mnt/data1/lxc-files/var_cache_lxc/ /var/cache/lxc
  7. mv /var/lib/lxc/* /mnt/data1/lxc-files/var_lib_lxc/
  8. rmdir /var/lib/lxc
  9. ln -s /mnt/data1/lxc-files/var_lib_lxc/ /var/lib/lxc
  10. lxc-ls
  11. Start a few containers and test


<yambe:breadcrumb>CentOS_7.x_lxc|CentOS 7.x lxc</yambe:breadcrumb>