CentOS 8.x iSCSI target server setup

From Notes_Wiki
Revision as of 17:32, 15 May 2022 by Saurabh (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Home > CentOS > CentOS 8.x > CentOS 8.x iSCSI > CentOS 8.x iSCSI target server setup

To setup CentOS 8.x machine for iSCSI target use:

  1. Create appropriate file-system and mount it at desired location (eg /backstores) to be used for storing iSCSI disk images (parted, mkfs.ext4, /etc/fstab, mount -a, df -h, etc.)
  2. Install targetcli package using:
    dnf -y install epel-release
    dnf -y install targetcli
  3. Clear existing configuration (if any) using:
    targetcli clearconfig confirm=true
  4. Go to /backstores in OS and create desired backing store using:
    cd /backstores
    qemu-img create -f raw primary.iscsi 800G
    where primary.iscsi is name of iSCSI backing store file and 800G is its size
  5. Run targetcli and configure it using:
    #Create file to be used as iscsi backstore
    cd /backstores/fileio
    create primary /backstores/primary.iscsi
    cd ..
    ls 
    #Note that we can also use block devices using /backstores/block
    
    cd /iscsi
    #This will create IQN number automatically
    #Ideally we should create different iqn numbers for every backstore
    #So that there is flexibility on client side.  We can run
    #create multiple times to create different iqn numbers.
    create
    cd iqn.<press-tab-to-autocomplete>
         
    #Create lun 
    cd tpg1/luns
    create /backstores/fileio/primary
    
    #Allow client IQN numbers without authentication
    cd ../acls
    create <client1-iscsi-initiator-name>
    create <client2-iscsi-initiator-name>
    
    #Save and exit
    cd /
    saveconfig
    exit
    
    Client initiator name is located in file '/etc/iscsi/initiatorname.iscsi'. Take only value after 'InitiatorName=' starting with 'iqn.'
  6. Configure service to start on system boot and also start it for current run:
    systemctl enable target
    systemctl start target
  7. Disable firewall or given exception for port 3260
    systemctl disable firewalld
    systemctl stop firewalld



Home > CentOS > CentOS 8.x > CentOS 8.x iSCSI > CentOS 8.x iSCSI target server setup