Difference between revisions of "Ubuntu HPC NTP client setup on compute nodes"
From Notes_Wiki
(Created page with "Home > Ubuntu > HPC setup with openpbs and openmpi > NTP client setup on compute nodes To configure client nodes to take their time update from master use: #Install ntp package #:<pre> #:: apt install -y ntp ntpdate #:</pre> #Edit '<tt>/etc/ntp.conf</tt>' file and '''keep only master server''' as follows: #:<pre> #:: server master prefer iburst #:</pre> # Se...") |
m |
||
Line 12: | Line 12: | ||
# Set correct time on current system using: | # Set correct time on current system using: | ||
#:<pre> | #:<pre> | ||
#:: systemctl stop ntp | |||
#:: ntpdate -b master | #:: ntpdate -b master | ||
#:</pre> | #:</pre> |
Latest revision as of 04:53, 23 February 2023
Home > Ubuntu > HPC setup with openpbs and openmpi > NTP client setup on compute nodes
To configure client nodes to take their time update from master use:
- Install ntp package
- apt install -y ntp ntpdate
- Edit '/etc/ntp.conf' file and keep only master server as follows:
- server master prefer iburst
- Set correct time on current system using:
- systemctl stop ntp
- ntpdate -b master
- Start and enable ntp service
- systemctl start ntp
- systemctl enable ntp
- Check status of ntp service
- systemctl status ntp
- ntpq -p
- We should see time getting synced with master with st value much less than 16.
Home > Ubuntu > HPC setup with openpbs and openmpi > NTP client setup on compute nodes